Your water heater is one pretty used and more expensive appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating as well as costs.
Regular flushing of one’s water heater is considered the single most important step you can take to prolong its service life and even save energy. A duration of time, sediments build up in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not just destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regions of the country, the typical water heater lasts 3-5 years. Regularly flushing your water heater can double the life of your hot water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater ‘s very important in today’s markets. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a month or so.
To drain your water heater, you can find should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is an electric heater). Failure to do so could result in overheating and severe damage to the heater. Next, close the water supply valve located more than a water inlet line going into your water heater. Then you’re connect a hose to the drain valve located at the base of the hot water heater. Open the drain and allow it to function until all of the water has emptied from the heating unit. Then close the drain. Open the water supply valve and refill the heating. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until the flows out smoothly. This will allow air to vent via the heater and the hot water lines. Finally, you can turn the thermostat for you to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your property to filter or condition the water so is actually always less corrosive to your plumbing system, particularly in areas possess hard water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in region to discuss options and products to provide what you need.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610